28ten
Guv'nor
I thought a couple of shots of tonights work on a commission for an engine shed might be of interest to those of you considering laser cutting.
First up a general shot of the side and some of the reveals
To make the correct thickness of the wall and allow full interior detail will require laminations to hide the glazing and give window frames on both sides
Note the outer layer will be mitred to get a nice crisp joint on the corners, whereas the inner laminations will form a butt to the shed front, which will have a similar set of laminations to the side, all of which gives a nice strong joint.
this last one shows the sheets exploded
First up a general shot of the side and some of the reveals
To make the correct thickness of the wall and allow full interior detail will require laminations to hide the glazing and give window frames on both sides
Note the outer layer will be mitred to get a nice crisp joint on the corners, whereas the inner laminations will form a butt to the shed front, which will have a similar set of laminations to the side, all of which gives a nice strong joint.
this last one shows the sheets exploded